tak, musi być wymuszone "przełączenie" na RGB napięciem.
Ok, jeżeli ktoś mógłby podlinkować jakiś łopatologiczny opis jak to zrobić to będę wdzięczny. W opisie schematu jest:
"The FUNCTION SWITCHING and BLANKING pins have not been connected in the
diagram above but may be required on some TV sets. In the unlikely event that manual AV
selection is not available for a TV set then +12V must be obtained from either the RS232
socket, the KEYPAD socket or the edge connector and connected directly to the FUNCTION
SWITCHING input. If the BLANKING pin needs to be connected in order to select the
SCART's RGB input then +12V or +5V must be obtained from either the RS232 socket,
KEYPAD socket or the edge connector and converted down to the appropriate voltage."
ale boję się żeby czegoś nie sknocić jak coś nie tak zlutuję.